Outdoor Cabinet 50"H X 42"D

ALUMISHIELD Top cover, shades cabinet from the sun
HANDLES Stainless steel - NEMA
RAILS Fully adjustable & alodine coated
DOORS Front and rear secured with three point locks and padlocking handles
VENTS Front & rear, top & bottom, filters supplied


The OD-50DDX is the superior design in communication cabinets, being as rigid as steel & yet noticeably lighter than the old heavy steel constructed cabinets. This is made possible with our own aluminum recipe called ALUMIFLEX. The OD-50DDX offers the protection needed for any sever outdoor environment. The OD-50DDX is constructed of .125 ALUMIFLEX material, & comes with an additional .125 ALUMISHIELD top cover, thereby fully protecting your equipment from falling ice and the sun's heat penetration. Ultimate security is provided by a three point locking system, which utilizes a NEMA stainless steel cabinets, the OD-50DDX, made of ALIMIFLEX, will operate without affecting or being effected by RF influences. Outdoor cabinets are becoming the alternative shelter solution for today's complicated zoning requirements. So weather your installing a new shelter or adding room to your existing one, the OD-50DDX is the ultimate solution.


SPECIFICATIONS

GENERAL
Weight: 178 lbs. assembled
218 Lbs. Shipping weight
Doors: Two - secured by three point locking system
Locks via customer supplied padlocks
sealed with 13/16" aluminum filled gaskets
Material: .125 ALUMIFLEX
Finish: Flat aluminum
RF properties: Non-ferrous
Vents: Twelve bottom louvers per door
Six top louvers - In top cover-under ALUMSHIELD
One removable filter panel per door
Six fixed filter pads in top cover
Handles: Stainless steel
Exterior Screws: Stainless with NEMA washers & nylon locking nuts

RACKING SPECIFICATIONS
Rails: Four standard (For additional rails see accessories)
Alodine coated
tapped to 10 x 32 threads
Each rail supported by three R-STRUTS
.125 Material (ALUMIFLEX)
Spacing: 19" EIA STANDARD
Positioning: All rails fully adjustable from front to rear
Useable Height: 50 inches
Useable Depth: Maximum: 38 1/2" Minimum 36 3/4" (See below)
*Section Starting
& Ending Points		 Vertical Height
Per Section		  Effective Depth
For Each Section
Top
 46.75" - 50.00"
46.57" - 46.75"
31.00" - 46.57"		 =
=
=		 3.25"
.18"
15.57"		 38 1/2"
37 1/2"
38 1/2"
Center 19.00" - 31.00"
3.43" - 19.00"
3.25" - 3.43"		 =
=
=		 12.00"
15.57"
.18"		 36 3/4"
38 1/2"
37 1/2"
Bottom 0.00" - 3.25" = 3.25" 38 1/2"
*Section measurements start from the bottom of the cabinet (0.00") & runs vertically upward towards the top of the cabinet (50.00"):

DOOR OPENING CLEARANCE
Width : 19 1/2 inches
Height : 45 13/16 inches

EXTERIOR CABINET DIMENSIONS
Main Body::
Width: 25 1/2 inches
Height: 50 1/4 inches
Depth: 42 1/4 inches
ALUMSHIELD:
Width 28 1/16 inches
Hang down height: 1 3/4 inches
Depth: 44 11/16 inches
Handles: Protrude 1 7/8 inches
Total Space Occupied:
Width: 28 1/16 inches
Height: 50 1/2 inches
Depth: 46 inches

INSIDE CLEARANCE - LESS RAILS
Width: 23 5/8 inches
Height: 50 inches
Depth: See racking Spec's - useable depth chart above


RATINGS
NEMA: CLASS: 250
TYPE: 4

WARRANTY
Period: Two Years - Unconditional
ACCESSORIES
R-2-50: Two extra 50" rails & mtg. hdw.
MTDDX: Mounting tray
CA-4: Caster kit (4) & mtg. hdw.
SCR-432: Rail Screws (4) 10x32

OPTIONS
P-DDX: Powder baked on textured paint

Paint Tested: 500 Hour salt spray
500 hour immersion

SHIPPING INFORMATION
The OD-50DDX is shipped fully assembled, but can easily be knocked down and reassembled at your site, if desired.