| GENERAL |
| Weight: 48 lbs. |
Doors: Two - secured with non-intrusion locks
Locks and unlocks with a supplied set of keys
Designed to mount either left or right |
Material: .1 ALUMIFLEX (our own aluminum recipe)
Finish: Grey, textured, powder baked on paint
RF properties: Non-ferrous |
Vents: Two - 8" X 10" standard filter panel housings
One removable filter panel per door
Solid panels can be used for non ventiliation |
| Access Holes: One - One inch hole / with hole plug installed |
| Exterior Screws: Stainless with nylon locking nuts |
| RACKING SPECIFICATIONS |
Rails: Two standard (for additional rails see accessories)
Alodine Coated
Holes drilled to accept tinnerman clips (see CL-4)
Each rail supported by two R-STRUTS
Material .125 ALUMIFLEX |
| Spacing: 19" EIA STANDARD |
| Positioning: All rails fully adjustable from front to rear |
| Usable Height: 42 inches |
Useable Depth: Maximum: 16 11/16" Minimum 14 15/16" (See below)
|
*Section Starting
& Ending Points |
|
Vertical Height
Per Section |
Effective Depth
For each section |
Top
|
40.32" - 42.00"
25.00" -40.32" |
=
= |
1.68"
15.32" |
...14 15/16"
...16 11/16" |
| Center |
17.00" - 25.00"
1.68" - 17.00" |
=
= |
8.00"
15.32" |
...16 3/16"
...16 11/16" |
| Bottom |
0.00" - 1.68" |
= |
1.68" |
...14 15/16" |
| *Section measurements start from the bottom of the cabinet (0.00") |
|
| DOOR OPENING CLEARANCE |
| Width: 19 1/2 inches |
| Height: 38 3/4 inches |
| EXTERIOR CABINET SPECIFICATIONS |
Main Body: Width: 23 1/4 inches
Height: 42 1/4 inches
Depth: 17 1/4 inches |
| Screws: Protrude 3/16" on each side |
Total Space Occupied: Width: 23 5/8 inches
Height: 42 1/4 inches
Depth: 17 3/8 inches |
| INSIDE CLEARANCE - LESS RAILS |
| Width : 21 3/16 inches |
| Height : 42 inches |
| Depth : See racking spec's - useable depth chart above |
| RATINGS |
NEMA: CLASS: 250
TYPE: 2 |
Paint Tested: 500 Hour salt spray
500 Hour immersion |
| WARRANTY |
| Period: Two years - Unconditional |
| ACCESSORIES |
| R-2-42: Two extra 42" rails & mtg. hardware |
| MTD: Mounting Tray |
| CA-4: 4 - Caster kit & mtg. hardware |
| CL-4: 4 - tinnerman clips 10 x 24 |
| SCR-4: 4 - rail screws 10 x 24 |
| C-17": Trough top cover & 10" fan access |
| ST-ST42: Stacking kit (stack two ST-42's) |
| ST-ST3042 Stacking kit (stacks ST-30 & ST-42) |
| SHIPPING INFORMATION |
| The ST-42D is shipped fully assembled, but can be easily knocked down and
reassembled at your site, if desired |
